Wie man Schleifkratzer poliert

G360 Super Fast Compound can be used to eliminate 3000 grit sanding and polish rapidly from P1500 to a deep gloss finish:

HIGH CUT - To eliminate P1500 sanding marks from conventional low bake clear coats and prepare the surface for MEDIUM CUT polishing, use:

Rotary - G360 Super Fast Compound with a G Mop Super High Cut Pad [RED]
Dual Action - G360 Super Fast Compound with a G Mop Super High Cut Pad [WHITE] 

MEDIUM CUT - To remove process marks, rapidly eliminate heavier swirls and holograms and leave an excellent gloss finish on light colours while preparing dark colours for FINE CUT polishing, use:

Rotary & Dual Action - G360 Super Fast Compound with a G Mop Angled Yellow Compounding Foam

See our dedicated Solution pages for full details - including handling instructions and recommended speeds:

How to Use: G360 Super Fast Compound
Process Guide: G360 Super Fast System for ROTARY Polishers
Process Guide: G360 Super Fast System for DUAL ACTION Polishers

No – on the contrary – the G360 Compound when used with a Super High Cut Pad runs very cool which is excellent for fresh paint but it does have a very high cut which is also really, really good on long cured paints and OEM paints.

G360 Super Fast Finish can be used to further enhance gloss levels of light colours and on dark colours to rapidly eliminate light swirls and holograms and leave an enhanced deep gloss finish.

Farécla recommend using with the G Mop Angled Finishing Foam (GMF622) - recommended speed may vary depending on your chosen applicator.

1. Ensure surface is clean, dry and cool to the touch
2. Shake bottle well before use
3. Apply a small amount of product onto the surface
4. Spread over the surface and polish at 800 - 1100 RPM
5. Work in small areas at a time, keeping the applicator flat to the surface
6. Wipe clean and repeat if necessary

1. Spray a light mist onto the surface.

2. Use a clean, G Plus Finishing Cloth to immediately wipe off polishing residues, glue lines etc.

3. Using a dry area of the cloth, or ideally a 2nd clean, dry microfibre cloth, buff the surface.

For tougher contamination like birdlime, allow the product to dwell for a few seconds before wiping

If left and dried on the surface – wet with more product