G3 Pro Surface Sanitiser

When a product listing is marked “[#] Discontinued”, the product line or SKU has been discontinued by Farécla.

Unless stated otherwise on the individual product page, Farécla stock has now been depleted. Remaining quantities may still be available through our distribution partners while residual market stock lasts.

Discontinued products remain visible on the website for a limited period to communicate the change and guide users towards suitable Farécla alternatives.

On the individual product page, alternative product recommendations are provided below this FAQ.

Over time these listings will be removed. Searches for discontinued part numbers will then redirect to the recommended alternative product(s) or a relevant support article.

HARD / NON-POROUS SURFACES

1. Spray liberally on the surface until fully saturated (i.e. visibly wet), then spray a small amount on to a clean, dry microfibre cloth

2. Wipe the surface with the cloth until fully covered. Ensure that difficult to reach/unseen areas (such as corners, gaps, channels etc.) are fully contacted

3. Leave the solution in contact with the surface for 5 minutes

4. Use a separate clean, dry microfibre cloth to remove any residue

SOFT / POROUS SURFACES (including fabric and leather)

1. Spray liberally on the surface until fully saturated (i.e. visibly wet)

2. - Wipe/brush the solution in difficult to reach areas (such as corners, gaps, channels etc.) using either a clean, dry microfibre cloth or soft brush

3. Leave the solution in contact with the surface for 5 minutes

4. Use a clean, dry microfibre cloth, soft brush or vacuum to remove residue