Clean and Protect is an easy to use “wipe on, wipe off” product - rapidly removing contaminants from paint, glass, rubber and plastics, whilst leaving a silicone-free layer of protection to the surface
G360
G360
Farécla G360 Super Fast Compound and Finish is a radical new polishing system developed to eliminate the need for expensive finer grit abrasives which many other compound/polishes do not.
Super Fast. Super Easy.
The Products
G360 Super Fast Compound is designed to rapidly eliminate sanding marks and minor defects from painted and lacquered automotive surfaces.
G360 Super Fast Finish easily eliminates swirl marks and other minor defects rapidly.
Step-by-step ROTARY polishing process guide for the G360 Super Fast System - developed for rapid removal of P1500 sanding marks, efficient refinement and permanent high gloss finishing on modern automotive clear coats.
Step-by-step DUAL ACTION polishing process guide for the G360 Super Fast System - developed for rapid removal of P1500 sanding marks, efficient refinement and permanent high gloss finishing on modern automotive clear coats.
Still want to learn more?
Top 10 tips to boost cost effectiveness with Farécla G360 Top 10 tips to boost cost effectiveness with Farécla G360
- Don’t overapply – use between 30% and 50% less compound than you would normally use with other brands. Use sparingly – too much incurs additional and unnecessary cost, extra clean up time, and can clog the pad reducing effectiveness of cut.
- For optimum performance in removing P1500 sanding scratches always use the White CCS Foam Waffle Pad. This reduces the need to use P3000 which reduces cost and cycle time.
- When using a rotary polisher ensure the machine speed is set to the correct level between 1500 and 1800 RPM – too low or too fast will result in low product performance and increase polishing cycle time.
- Apply light pad pressure. Don’t lean on the polisher or hold it at too steep an angle – it might sometimes cut quicker, but holograms and therefore reworks can result.
- Don’t polish for too long – this can put micro-scratches into the surfaces, which then take more time to get out. Using products that have a transparent film can help.
- Knead a brand new foam before first use and prime it with compound – this stops any initial “scratchiness” and prompts more effective polishing at the outset.
- Always spur foam and wool polishing pads regularly. Wash them out with warm water and leave to dry overnight to prolong the life of pads. A build-up of compound from previous jobs will reduce cut and cause skating. Dried compound can put scratches into the surface.
- Avoid polishing under-cured paint (paying particular attention to the baking oven panel bake temperature and cold spots, gun set-ups, spraying technique. Soft paint cannot be polished effectively and may require reworking at a later stage.
- Always use two microfibre cloths (dirty and clean) – learn the folding technique for always using a clean section of microfibre to avoid marring the finished surface.
- Finally, good housekeeping is paramount to a successful outcome. Ensure all machinery is in a well maintained and clean state ensure all pads are washed and spurred regularly.
Great results without P3000. Faster, and less reworks.
Rye Street Group
The speed, efficiency and quality finish of G360 makes it a perfect fit for us. The absence of reworks is also a big plus.
Xpress Centres
P3000 is no longer necessary – saving time and money. Very good shine and only with a G360 polish.
Hein & Mantek
No need for P3000, so cost-effective, faster system.
Halliwell Jones
A look at how Farécla saved CarShop time and money polishing vehicles being prepared for their busy car supermarket.